Creda Colonial Manual do Utilizador

Instructions for Installation and UseSealed Plate HobsTo the InstallerBefore installation fill in the product details on the back cover ofthis booklet

SOMETHING WRONG ?Before contacting your Creda Service Centre / Installer, check the following; there may benothing wrong with your appliance.PROBLEMNo

Cleaning materials to avoid.1. Household abrasive powders, e.g. Vim.2. Oven chemical cleaners, aerosols and oven pads. Caustic cleaners such as these

WARNING - THIS APPLIANCE MUST BE EARTHEDSITING THE HOBINSTALLATION12All Creda hobs are suitable for installation over any Creda Build-in or Build-Unde

13INSTALLATIONFig. 1IMPORTANTMinimum unobstructed depth50mmWorktop thicknessPreferred 30-40mm19mm minimumrecommended30mm490mm560mmFront edgeof worktop

Key ContactsServiceCreda has the largest appliance manufacturer’s service team in Europe,trained specialists directly employed by us to ensure your co

For more information on our exciting product range ringCreda Answer Centre 0541 54 64 74ORVisit us on the NET athttp://www.creda.co.ukGeneral Domestic

Introduction 4CONTENTSFor Your Safety – Always 5For Your Safety – Never 6Using Your Hob 7 - 9Something Wrong ? 10Care & Cleaning 11Installation 12

INTRODUCTIONYour new hob is guaranteed* and will give lasting service. This guarantee is only applicable ifthe appliance has been installed in accorda

FOR YOUR SAFETYWhen used properly, your appliance is completely safe but as with anyelectrical product there are certain precautions that must be obse

NEVER●Never leave children unsupervised where a cooking appliance is installed as all cooking surfaces will be hot during and after use.●Never allow a

USING YOUR HOB7● Use good quality flat-basedcookware on all electric heatsources.● Ensure pans have clean, drybases before use.● Ensure pans match siz

OPERATION WHEN USING THE SEALED PLATE HOBStep 1 Place the saucepan centrally on the required hotplate.Step 2 Turn the required hotplate control knob t

USING YOUR HOB - FEATURES13249The rating plate for all the models is situated on the underside of the base panel.213413242134Heating Areas : (1) 1.0 k